Active Pour Tap
Articles regarding Active Pour Tap
My brew is too frothy or fizzy - Pinter 3
If your beer is too frothy at the point of dispense this may be due to the following reasons:. Conditioning your Brew is a vital step. It adds key tasting notes to your Beer or Cider and allows the CO₂ produced naturally by the yeast during the ferme
My Tap Handle has broken
We are very sorry that your Tap Handle for your Active Pour Tap has broken. The most common reason for this to happen is the Tap Handle being put on and used back to front. Please ensure the screw is facing backwards, so not visible from the front of
My Active Pour Tap is dripping
A small drip is to be expected after dispensing from your Pinter using the Active Pour Tap. This is perfectly normal and isn't anything to worry about. Please simply leave your glass underneath for a couple of seconds to allow the last few drips to f
My Active Pour Tap is stuck
We are sorry to hear you are unable to remove your Active Pour Tap from your Pinter. Not to worry, we're here to help!. The Active Pour Tap can sometimes be a little tricky to remove at times, especially if any residual brew has been allowed to dry.
Do I need to buy a Pinter and an Active Pour Tap together?
No, you don’t need to purchase the Pinter and the Active Pour Tap separately - the Active Pour Tap is included as standard with the Pinter 3 and Co-Pinter, so there’s no need to buy one in addition. If you have a Pinter 2 and would like to upgrade yo
How does the Active Pour Tap work?
The new Active Pour Tap puts you in complete control of the beer you serve. It adapts to any pressure state inside the Pinter. All you need to do is pull the Tap Handle. Start by pulling the handle down slowly when your beer is freshly brewed, then p
My Active Pour Tap stopped pouring
If your Pinter has stopped pouring, it’s usually due to low internal pressure. As the Pinter gets near empty, pressure naturally drops. To pour the final few pints: Turn the Carbonation Dial on the back to “OFF” - this makes it easier for the remaini
Is the Active Pour Tap backwards compatible?
The Active Pour Tap comes as standard with the Pinter 3 and is fully compatible with the Pinter 2. You can upgrade your Pinter 2 by ordering it through our website here.
My Tap is leaking from the Tap connection to the Pinter (the Collar)
🚨 If your Pinter has been brewing for more than an hour, it will be under pressure. Before removing any parts, it’s very important to release that pressure safely. To do this, slowly turn the Carbonation Dial to the OFF position for 10 seconds, then